Plasplugs Hollow Door Plugs & Drill Bit 20 Pack

Product Information

To allow the construction adhesive to cure and stick the batten to the door you will either need to screw it in place while it dries, take the door off and lay it flat and then put the batten in place or try and clamp it with the door still on.

Specialist Fixings - Plasplugs Specialist Fixings - Plasplugs

Many modern interior flush doors have a hollow core often consisting of little more than a honeycomb of corrugated cardboard to provide rigidity, and a thin plywood skin covered in a vinyl or foil decorative finish. If leaving the door in place and holding with screws, you can either use the hollow door fixings mentioned above or just use some standard screws, we will be using the latter in this case. Firstly, cut your batten to the correct length for your needs and then sand off the rough cut edge so it’s nice and smooth. In most cases if you are hanging heavy items, unless the fixing is supported from below as in the hook diagram above, the weight of the item will eventually cause the fixing to drop.We and our partners use data for Personalised ads and content, ad and content measurement, audience insights and product development. Using round rose handles: The lock or latch will likely obstruct any fixing screws resulting in too little wood to achieve a decent screw fixing.

Plasplugs DR308 DR 308 Hollow Door Fixings (10) PLADR308

For the purposes of this guide we are going to run through two of the above techniques for fixing to a hollow door. As it’s planed we don’t need to sand it down, but if you are using just sawn batten, give it a good sand down first and once painted this will produce a good finish.x Hollow Door Regular Duty Fixings for use in Hollow Doors, Thin Skin Partitions, Plywood and Fibreglass. The lock block can be quite small to save on manufacturing costs and if the door has accidentally been hung with the hinge side (the hanging stile) on the swing side, there may be no lock block to find at all! In this case you need to use bolt through fixings together with a lock or latch which has pre-drilled through fixing holes. In this DIY guide we show two methods of fixing to hollow doors, one using specialist hollow door fixings and the other using construction adhesive. Lay your piece of batten face down and apply several thin beads of construction adhesive across the face of the timber.